In this page you will find constantly new software and release for amateur seismology. Stay tuned!
 

• SEISMOWIN
  
• SEISMONET
• WinQuake
  

Features
- Support up to 4 channels
- Sampling rate adjustable from 0.1SPS to 100SPS per channel
- Automatic event recording
- Amplitude triggering or STA/LTA triggering
- Offset adjustement manual or automatic
- Virtual drums with JPG saving format
- Track data buffer to recover events passed under the recording threshold
- Scope drawing of the tracks
- Drawing speed adjustable
- Flexible triggere parametrization for easy recording of teleseismic or local events
- ASCII recording of the tracks for easy porting of data to any seismic software analyzer
- Direct compatibility with WinQuake software
- Playback (Review) of the logged tracks
- RAW binary 16 bit datalog format for easy WAV file generation
- Possibility to select different sample speed for each channel
- Hardware and software watchdog support
- Hardware and software event alarm support
- Complete integration of DCF77 time decoder receiver embedded on the SADC10 card
- Possibility to use other PC syncronization solution even using the SADC10 card (GPS, NMTP)
- Accurate timing management down to second fractions
- EMAIL and SMS management with other software supported
- Windows under 640x480 resolution for support of olds PC graphic cards
- MiniWizard to easy regional/teleseismic STA/LTA and triggering setup
- Calibration window to make the data scientifically valuables
- JTF and Frequency Domain FFT Spectrum analyzer with Peterson's curve direct comparison
- The supported boards are:
   + SADC10 16 bit a/d board 4 channell
   + SADC18 18 bit a/d board 4 channell
   + SADC20 24 bit a/d board 3 channell
   + SADC30 16 bit a/d board 16 channell (only 4 supported)
   + LX1500 Nuova Elettronica's a/d 16 bits board
   + DATAQ 12 bit 4 channel board
   + Infiltec David Saum's a/d 16 bits board